BetaFPV Meteor O4 betaflight setup problems If you…
0 reactions
BetaFPV Meteor O4 betaflight setup problems
If you followed this tutorial https://www.youtube.com/watch?v=dAtAfFO137U and got stuck because you can't switch to SBUS I found out how to fix it
1. Press Update Firmware (top tool bar)
2. Enable Expert Mode and select Full Chip erase
3. Press detect and choose the latest version
4. Change build config to this:
https://preview.redd.it/71kxv6yphfug1.png?width=1219&format=png&auto=webp&s=0544d8c23e4bd30fec68242929a3ff5e8fa1fdad
5. Press load firmware (online) then press flash
6. Your drone should enter DFU and your browser will ask you to select the drone in DFU mode usually named "STM32 BOOTLOADER" or "DFU in FS Mode"
6a. If you don't see anything when your browser prompts, you have to download Zadig If it isnt already in DFU, unplug your drone, hold the boot button (next to the antenna) and plug it back in while holding it to enter DFU
In Zadig options, press list all devices, select "STM32 BOOTLOADER" or "DFU in FS Mode" and install WinUSB driver then close Zadig and retry flashing (exit dfu by unplugging and plugging back in)
7. Keep following the tutorial
Also Im not an expert on this I literally got my first full FPV today and just had the same problem
#technology
source
If you followed this tutorial https://www.youtube.com/watch?v=dAtAfFO137U and got stuck because you can't switch to SBUS I found out how to fix it
1. Press Update Firmware (top tool bar)
2. Enable Expert Mode and select Full Chip erase
3. Press detect and choose the latest version
4. Change build config to this:
https://preview.redd.it/71kxv6yphfug1.png?width=1219&format=png&auto=webp&s=0544d8c23e4bd30fec68242929a3ff5e8fa1fdad
5. Press load firmware (online) then press flash
6. Your drone should enter DFU and your browser will ask you to select the drone in DFU mode usually named "STM32 BOOTLOADER" or "DFU in FS Mode"
6a. If you don't see anything when your browser prompts, you have to download Zadig If it isnt already in DFU, unplug your drone, hold the boot button (next to the antenna) and plug it back in while holding it to enter DFU
In Zadig options, press list all devices, select "STM32 BOOTLOADER" or "DFU in FS Mode" and install WinUSB driver then close Zadig and retry flashing (exit dfu by unplugging and plugging back in)
7. Keep following the tutorial
Also Im not an expert on this I literally got my first full FPV today and just had the same problem
#technology
source
| 2,000 mlx | |
| 2 | |
| 0 |