Bambu P1S AMS - Not retracting filament after finished…
0 reactions
Bambu P1S AMS - Not retracting filament after finished print + Error
For some reason my AMS is able to push the filament to the nozzle for printing. But once the print is done or if it needs to retract and replace with a different filament, it throws an error saying there was an issue with retracting filament from nozzle. I can pull it out just fine by detaching and the PTFE tube on the back, then once resumed it retracts. And even with all that, it is printing just fine.
Any ideas?
#technology
source
For some reason my AMS is able to push the filament to the nozzle for printing. But once the print is done or if it needs to retract and replace with a different filament, it throws an error saying there was an issue with retracting filament from nozzle. I can pull it out just fine by detaching and the PTFE tube on the back, then once resumed it retracts. And even with all that, it is printing just fine.
Any ideas?
#technology
source
| 2,000 mlx | |
| 3 | |
| 0 |