Shrinkage after printing I'm printing these can mugs as…
0 reactions
Shrinkage after printing
I'm printing these can mugs as giveaways. They were all tested after printing and they all fit. Now, a month or so later they no longer fit. The two most recent prints still do, but are snugger than they were. What can I do to fix this?
Everything is now trash, and I'm so frustrated.
Edit, sliced with Orca, printed with different PLAs, did print tests with each pla and used recommended temps based on box and print tests.
#technology #3d #3dprinting
I'm printing these can mugs as giveaways. They were all tested after printing and they all fit. Now, a month or so later they no longer fit. The two most recent prints still do, but are snugger than they were. What can I do to fix this?
Everything is now trash, and I'm so frustrated.
Edit, sliced with Orca, printed with different PLAs, did print tests with each pla and used recommended temps based on box and print tests.
#technology #3d #3dprinting
| 3,000 mlx | |
| 6 | |
| 0 |