Supports? Where we‘re going, we don’t need supports! This…
0 reactions
Supports? Where we‘re going, we don’t need supports!
This is a part I was working on with a 90° overhang on each side. To see if it works, I printed it in this orientation and with non-planar layers.
Cooling could be a bit better for the bottom surface, but other than that, it works quite nicely.
#technology #3dprinting #3d
This is a part I was working on with a 90° overhang on each side. To see if it works, I printed it in this orientation and with non-planar layers.
Cooling could be a bit better for the bottom surface, but other than that, it works quite nicely.
#technology #3dprinting #3d
| 3,000 mlx | |
| 4 | |
| 0 |