Drilling angled holes, results are not plumb. How do I do…
0 reactions
Drilling angled holes, results are not plumb. How do I do this?
I'm trying to drill holes at a 45° angle.
I got my angle dialed in, but every hole I drill is no longer plumb- it enters in the center of the work piece but exists off to the side. I want simple angles but I'm getting compound ones.
Is there a better way to set up to avoid this? Thanks a ton, this project sucks
#diy
source
I'm trying to drill holes at a 45° angle.
I got my angle dialed in, but every hole I drill is no longer plumb- it enters in the center of the work piece but exists off to the side. I want simple angles but I'm getting compound ones.
Is there a better way to set up to avoid this? Thanks a ton, this project sucks
#diy
source
| 5,000 mlx | |
| 5 | |
| 0 |