Help with corexy bracketry Im trying to throw together a…
0 reactions
Help with corexy bracketry
Im trying to throw together a custom corexy machine to replace my ender and currently im just trying to wrap my head around the motion system, id like to use the reaper toolhead as it has everything i need and I find it to be a very nice looking design, however the rail mounting position is on the back, I was planning on modifying bracketry from different corexy setups to fit my specific use case, 3 leadscrews for z, with linear rods as the z guides, and 3 mgn12s, 2 for y, 1 for x to have the most minimal footprint I wanted to opt for side mounted rails on y so my panels will fit in the 2020 extrusion slots, front mounted rail for the toolhead, however i can't find any setups that do this? Ratrig has a top mounted x rail and side mounted y rails, and the trident has bottom mounted y rails.
I can only assume the reasoning to this is for belt routing, since the belt has to travel through the x gantrys extrusion on the voron and ratrig just uses the opposite side, so wouldnt it just be possible to design the joiner with a tunnel where there is enough distance for a 9mm belt to pass between the mgn block and X extrusion?
#3dprinting #3d #technology
source
Im trying to throw together a custom corexy machine to replace my ender and currently im just trying to wrap my head around the motion system, id like to use the reaper toolhead as it has everything i need and I find it to be a very nice looking design, however the rail mounting position is on the back, I was planning on modifying bracketry from different corexy setups to fit my specific use case, 3 leadscrews for z, with linear rods as the z guides, and 3 mgn12s, 2 for y, 1 for x to have the most minimal footprint I wanted to opt for side mounted rails on y so my panels will fit in the 2020 extrusion slots, front mounted rail for the toolhead, however i can't find any setups that do this? Ratrig has a top mounted x rail and side mounted y rails, and the trident has bottom mounted y rails.
I can only assume the reasoning to this is for belt routing, since the belt has to travel through the x gantrys extrusion on the voron and ratrig just uses the opposite side, so wouldnt it just be possible to design the joiner with a tunnel where there is enough distance for a 9mm belt to pass between the mgn block and X extrusion?
#3dprinting #3d #technology
source
| 2,000 mlx | |
| 4 | |
| 0 |