Was I using the wrong tool for the job? So currently, I'm…
0 reactions
Was I using the wrong tool for the job?
So currently, I'm trying to cut up some railing to recycle with the oscillating multi-tool. either I'm doing something wrong, or it's just not the right tool for the job because I went through three carbide blades with each blade, only making like two or three cuts before chipping.
I'm not sure if I was putting too much pressure on the blade or if the piece was getting work hardened or maybe oscillating tools are just aren't meant to do wide bar.
I was initially using a Sawzall, which was doing the job, but it died on me.
#industry
So currently, I'm trying to cut up some railing to recycle with the oscillating multi-tool. either I'm doing something wrong, or it's just not the right tool for the job because I went through three carbide blades with each blade, only making like two or three cuts before chipping.
I'm not sure if I was putting too much pressure on the blade or if the piece was getting work hardened or maybe oscillating tools are just aren't meant to do wide bar.
I was initially using a Sawzall, which was doing the job, but it died on me.
#industry
| 2,000 mlx | |
| 4 | |
| 0 |